![]() ![]() It is possible to connect loads with different voltages or loads with activation impulse. The connection is illustrated again in the operating instructions. Finally, you put the glass front on the switch, put the fuse back in and your lamps can be smartly controlled. Now push all the wires back into the wall and ***** the iotty underground to the wall or the old light switch holder. Then you wire the phase with the ***** terminal RL 1 (left side) and the phase of the lamp with the ***** terminal RL 1 (right side). The phase comes into the terminal marked L (load). The neutral conductor is then inserted and screwed into the terminal marked N on the iotty. The neutral conductor of the old switch is required to install the iotty Smart Switch. Before you do that, turn off the fuse for the switch you are replacing! After the old switch has been removed, you mark the cables. To install the iotty Smart Switch you first have to remove the old lamp switch. Any other ohmic load with a maximum of 5A, minimum load 3W Halogen, energy-saving, incandescent, fluorescent or LED lamps with. WLAN 802.11 only works with the 2.4 GHz band Wi-Fi 802.11 b / g / n / e / i, Wi-Fi direct. The Switch will receive an SNES controller this year
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |